CurseForge · Minecraft mod
Simpleretrogen
Utility to allow easy retrogeneration for IWorldGenerator based content
Quick answer
Which Simpleretrogen release matches 1.10?
simpleretrogen-1.10-4.0.1+8.jar targets 1.9.4, 1.10.2, 1.10. The project page does not say whether this file belongs on the client, dedicated server, or both. No extra mods listed for this file.
Where it goes
Is Simpleretrogen required on the client, server, or both?
The project page does not say whether this file belongs on the client, dedicated server, or both.
The source does not explicitly classify this release as client-only or server-only.
What else does simpleretrogen-1.10-4.0.1+8.jar need?
simpleretrogen-1.10-4.0.1+8.jar on 1.10. Every mod below is checked against that same setup.
This file does not list any required mods. Do not add a library just because a different file uses it.
This file does not list any required or optional mods.
Before you install it
Add Simpleretrogen without breaking your instance.
Built for simpleretrogen-1.10-4.0.1+8.jar on 1.10. Pick another file and the loader, install side or required mods may change.
- 01
Stick to this file
Use simpleretrogen-1.10-4.0.1+8.jar. It targets 1.9.4, 1.10.2, 1.10; another release may have different loader, side or dependency requirements.
- 02
Bring the mods it needs
This file does not list any required mods. Do not add a library just because a different file uses it.
- 03
Put it on the correct side
The project page does not say whether this file belongs on the client, dedicated server, or both.
- 04
Pick the file you checked
Use the “Get this file” button beside simpleretrogen-1.10-4.0.1+8.jar. It opens that exact file at the source.
About this project
What does Simpleretrogen add?
Simpleretrogen is a utility mod that allows mods with world generation to perform re-injection of their content into existing generated chunks, and tracks which ones have been retrogenerated.
This allows you to add a new mod to your world and have it's content retrogenerated into existing chunks.
It works with the IWorldGenerator based system from FML used by most mods to inject simple content into world generation.
Commands:
There is one helper command at present.
- listretrogenclasstargets - list the classes on the server which are candidates for adding to simple retrogen.
Configuration:
To configure this mod you need to figure out which classes implement IWorldGenerator from the mod(s) you wish to regenerate.
As an example, slimeknights.tconstruct.world.worldgen.SlimeIslandGenerator is the worldgenerator for slime islands in Tinkers Construct.
The configuration file has been restructured for 1.9. You can have more than one "mark" in the file, each containing its own classes for retrogen. You can activate and deactivate sections by adding them to the "markerList" list.
# Configuration file########################################################################################################### CPWRGMARK#--------------------------------------------------------------------------------------------------------## Marker definition# You can create as many of these as you wish# Activate by adding to active list##########################################################################################################CPWRGMARK { # World Generator classes for marker S:worldGens <slimeknights.tconstruct.world.worldgen.SlimeIslandGenerator >}general { # Active markers S:markerList < CPWRGMARK > # Maximum number of retrogens to run in a single tick I:maxPerTick=100}
The example above will force slime islands to regenerate if they haven't been. The marker value allows changing the marker, which is applied to any regenerated chunks, so changing the value will force the regenerations to run again. MaxPerTick controls how many chunks will be regenerated each tick, to ensure that the cost of regeneration doesn't cause an unacceptable slowdown to your server.
Project description from CurseForge.
Pick your setup
Simpleretrogen by Minecraft version and loader
Choose the version and loader you play, then open the matching release.
1.10
1 loader build1.9.4
1 loader build1.9
1 loader build1.8.9
1 loader buildCheck the dependencies, then try the file in a copied instance before changing a world you care about.
Recent files
Simpleretrogen versions and loaders
simpleretrogen-1.10-4.0.1+8.jar
23 Jun 2016
Looking for an older file? The official CurseForge project page is in Resources.