Back to mods
In Control! project artwork

CurseForge · Minecraft mod

In Control!

Be In Control of mob spawns

Choose a version Pick your version below, then grab the matching file.

Quick answer

Which In Control! release matches 1.20.1?

Updated 6 months ago
Best match for your filters 1.20-9.4.6
Game version 1.20.1
Loader Forge

In Control! 1.20-9.4.6 targets 1.20.1 with Forge. Do not install it on the client. It must be installed on the dedicated server. No extra mods listed for this file.

Where it goes

Is In Control! required on the client, server, or both?

Do not install it on the client. It must be installed on the dedicated server.

Client Not supported
Dedicated server Required
Loader for this release Forge
Required install it here Optional supported, not mandatory Not supported do not install here Source doesn’t say do not assume

This file is marked server-only.

What else does In Control! 1.20-9.4.6 need?

1.20-9.4.6 on 1.20.1. Every mod below is checked against that same setup.

No extra mods listed for this file

This file does not list any required mods. Do not add a library just because a different file uses it.

1 listed on this file 1 pulled in by one of those mods
The Lost Cities Optional for In Control! 1.20-9.4.6
optional
Matching file found Matched file: 1.20-7.5.0
The One Probe Needed by The Lost Cities
pulled in
Matching file found Matched file: 1.20.1-10.0.3

1 extra mod was pulled in by another dependency. Indented rows show who needs each one. We only count dependency files that match this setup. A file for another loader does not fill the gap.

Before you install it

Add In Control! without breaking your instance.

Built for In Control! 1.20-9.4.6 on 1.20.1. Pick another file and the loader, install side or required mods may change.

  1. 01

    Stick to this file

    Use 1.20-9.4.6. It targets 1.20.1 with Forge; another release may have different loader, side or dependency requirements.

  2. 02

    Bring the mods it needs

    This file does not list any required mods. Do not add a library just because a different file uses it.

  3. 03

    Put it on the correct side

    Do not install it on the client. It must be installed on the dedicated server.

  4. 04

    Pick the file you checked

    Use the “Get this file” button beside 1.20-9.4.6. It opens that exact file at the source.

About this project

What does In Control! add?

This is a simple mod that gives you full control on where mobs are allowed to spawn. It is based on a rule system. The rule files are located in config/incontrol.

Introduction

There are currently five rule files (as of 3.5.1):

  • spawn.json: with this file you can block spawning of certain creatures under certain conditions. In addition, when a spawn is allowed you can also alter some of the properties of the mob like maximum health and others
  • summonaid.json: this is a file that is structured the same as spawn.json but is only used when zombies are summoned for aid
  • potentialspawn.json (1.12 only): with this file you can remove and add spawn rules under certain conditions. The rules in this file are used before the rules in spawn.json are fired so make sure that when you add a rule for new mobs here, the new mobs are allowed in spawn.json
  • spawner.json (1.16 or later): with this file you can add spawn rules under certain conditions
  • loot.json: with this file you can control the loot that mobs drop when they are killed based on various criteria
  • experience.json: with this file you can control how much experience you get from killing mobs based on various criteria

More in-depth documentation can be found in this wiki: In Control! Wiki

Also check the companion mod: Fx Control

Note! Comments have been disabled because it is hard for me to check for this on too many places. If you want to submit a bug report then go to the 'Issues' tab or here: InControl Issue Tracker. If you want to discuss RFTools in general you can do that here: In Control on my discord


Usage

This mod can be freely used in any modpack.

Project description from CurseForge.

Pick your setup

In Control! by Minecraft version and loader

Choose the version and loader you play, then open the matching release.

7 available setups

Check the dependencies, then try the file in a copied instance before changing a world you care about.

Recent files

In Control! versions and loaders

55 of 147 releases match
Clear filters

Looking for an older file? The official CurseForge project page is in Resources.